Tuffy-security 275 Manuel d'utilisateur télécharger pdf (Page 6)

Page 6 of 6 – 1/28/2011 – Rev12/13/2011

OPTIONAL SECURITY FASTENER STEPS

• After all adjustments and checks have been made the optional security fasteners can be added if desired. Remove

both the OEM inside wheel liners under the tub.

WARNING! - Make sure that there is nothing under the vehicle that will be damaged by the drill bit when drilling. The

exhaust is located in that area, be cautious not to touch it when hot.

• Mark the tub under the center hole in the #10 Large bracket (or #11 Small bracket if desired) on both wheel wells and

drill a 3/8” hole in each. It is recommended to use silicone sealant on any drilled holes to prevent rusting. (See Figure

• Secure brackets to the vehicle using #15.25 bolts, #15.18 Washers and #15.21 nuts through each hole drilled. (See

Figure 5)

• Reattach OEM inside wheel liners under tub.

Figure 5

2-DOOR REAR SEAT STORAGE INSTRUCTIONS

The rear seat can be stored, folded and tumbled in 2-door models, with the deck enclosure installed, with some limitations

and adjustments.

LIMITATIONS: With the rear seat tipped forward the front seats will only recline to approximately 17 degrees when they

are positioned in the extreme rear setting. (This may end up too upright for tall people)

INSTRUCTIONS: Fold and tumble the rear seat. Unlatch the rear seat from both connection points on the left and right

side. Then re-latch the rear seat to only the front connection points on the left and right side. This tips the seat forward

enough to clear the deck enclosure when installed. The headrests can also be removed if more room is necessary but

this is typically not required.

IMPORTANT! Don’t forget to re-latch the rear seat to both connection points when use is desired again.

Call (970) 564-1762 for Technical Support

1 2 3 4 5 6

Pas de commentaire

Tuffy-security 275 Manuel d'utilisateur Page 6